Support>>

ORIGINAL INSTRUCTIONS
Read these instructions carefully before you attempt to use this product. Only qualified engineers/electricians
suitably trained should undertake the installation and commissioning of this product.
USE OF PRODUCT
∗ Wear eye protectors.
∗ This product must only be used for the purpose of pumping/evacuating air.
∗ Do not pump or evacuate any other gases or liquids.
∗ The performance of the product will be adversely effected at high altitudes.
∗ This product must be protected from inclement weather. It is not suitable for exterior use.
∗ Do not stay in line with the air stream.
∗ Do not try to obtain higher pressures or vacuums than those recommended. Refer to technical data sheet supplied.
INSTALLATION
∗ Refer to the technical sheet supplied for full technical specification.
∗ Only qualified electricians should undertake the wiring of the electric motor.
∗ The wiring of the electric motor should be made in accordance with local electrical regulations.
∗ Check that the mains supply voltage is correct for the product - see nameplate. Contact the
factory immediately if the voltage conditions are different.
∗ Do not touch the product during and just after operation as all parts of the product get very hot.
∗ Do not lubricate any part of this product.
∗ Do not install with pipes that are smaller than the size at the head ports.
∗ Fit a recommended filter/muffler to the inlet/exhaust port.
MOUNTING
∗ Mount the product in the horizontal plane using anti-vibration mounts. Contact factory for details.
INITIAL STARTING AND PUTTING INTO
SERVICE
∗ Wear eye protectors.
∗ Do not stay in line with the air stream.
∗ The product will start as soon as the electricity is switched "ON".
SHUTDOWN AND STORAGE
∗ Turn the electricity supply "OFF".
∗ Vent all pressure/vacuum from the product and/or system.
∗ Disconnect the product from the pipework.
∗ Do not stay in line with the air stream.
∗ Turn the electricity supply "ON" and run the product open to atmosphere for approximately15 minutes.
∗ Leave the product to cool down.
∗ Turn the electricity supply "OFF" and disconnect the motor from the electrical supply.
∗ The unit is now ready for storage.
PRODUCT FAILURE
Should the product fail to operate for any reason:
∗ Disconnect the electricity supply.
∗ Do not attempt to dismantle any part of the product before the electricity is disconnected.
∗ Refer to the Trouble Shooting Guide.
∗ Contact the factory or distributor for further advice.
∗ When the fault has been rectified the productwill operate as soon as the electricity supply is switched "ON".
MAINTENANCE & SERVICE
∗ Switch the electricity supply "OFF" and isolate the product.
∗ Vent all pressure/vacuum from the product.
∗ Inspect inlet filter/exhaust muffler elements and replace when necessary.
∗ Filters will become blocked quickly in dirty environments. Establish service periods by checking condition after 200 hours.
∗ Connect electricity supply and switch "ON".
∗ The product will start immediately. Service kits are available, follow the instructions supplied with the kit. Should the product require more than a maintenance service it is recommended you contact the manufacturer or authorised distributor.